LED strip accessories | Power supplies and controllers – Page 4

What you need for a complete installation

Power supply for 12V and 24V: watts per meter × number of meters ÷ 0.8. See the LED strip power supplies.
Connectors and cable to join, make corners and connect the power supply, without soldering. Check the width (8, 10 or 12 mm) and number of pins. See the LED strip connectors.
Controller and remote to dim, choose the color temperature or control color, with a remote, wall panel, app, Matter, Zigbee or DMX. See the dimmers and controllers.
Start and end caps to seal IP65 strips watertight after cutting.
230V parts: plugs, couplers, corner pieces and end caps for the 230V strips. See the 230V LED strips.

Voltage: power supply, controller and strip must have the same voltage (12V or 24V).
Channels: single color, CCT, RGB, RGBW or RGB+CCT. Controller and connectors must have the same number of channels as the strip.
Width: the connector must match the width of the strip.
Moisture: with IP65 strips, also IP65 connectors, end caps and a waterproof power supply.

Prefer no separate parts? The LED strip sets include the strip, power supply and connection, and with color sets also a controller with remote.

One with the same voltage and at least 25% headroom. Add up the watts of all strips and divide by 0.8.

A connector with the same width and number of pins as your strip: 2 for single color, 3 for CCT, 4 for RGB, 5 for RGBW and 6 for RGB+CCT.

Yes, with a WiFi or Matter controller, or with a gateway that connects your RF controllers to the app.

With a matching end cap, or a start cap at the connection side. Choose the cap that matches the strip type.